Skip to main content

Adding a Controlant Go device to a shipment

In this section:

Below you will find the steps to take when adding a Controlant Go device to a shipment.

  1. Retrieve the Controlant Go devices from the box or shelf.

  2. Check the label on top of the device to verify the following:

    Controlant Go device label showing preconfigured temperature range, calibration expiry date, and unique link to shipment report

    1. Pre-configured temperature range matches the temperature range of the shipment you are adding device to.

    2. Expiry date is not during expected shipment duration.

  3. Check display and verify that the shipment status of the device is Paired.

    Paired Saga device

    Note

    If the status is Shipping, device has already been activated, and temperature monitoring has started. Set the device aside and contact Controlant.

  4. To ensure battery level is sufficient for the duration of the shipment, check battery level of the device.

    Tip

    The minimum battery level for a 30-day shipment is 80%.

    Paired Saga device

    Note

    If battery level is below the desired threshold, do one of the following:

    • select a different device.

    • connect the device's USB cable to a USB port until fully charged. For more information, see Charging the device.

  5. Place device with goods and press and hold the start button controlant saga logger start buttonfor 5-8 seconds on the device to start the shipment.

    The shipment LED controlant saga device shipment led lights up when the device registers the button press as valid and remains on for 3 seconds. The lit-up LED light means that you can release the button.

    Shipment status on device display changes to Shipping.

    Your shipment is ready to go!

Printable process overview

Adding a Controlant Go device to a shipment (PDF)